ABSTRACT
FLUSHING OF THE CONDENSER
The refrigerant gas let into the condenser through the compressor and the vacuum pump was connected to the condenser to absorb dirty.
REFILLING OF GAS INTO THE COMPRESSOR
Gas was refilled into the compressor due to shortage of gas and it was filled inside the charging value and refrigerant.
CHANGING OF DRIVER STRAINER DUE TO BLOCKAGE
The driver strainer was change due to blockage with the help of oxygen and acetylene welding.
SPRAYING OF THE FRIDGE
The compressor was put on and the compressed air through the holes to the gun due to high pressure inside the tank. The air then forces the point out of the gun for spraying.
TABLE OF CONTENT
Title Page
Release Page
Transmittal Page
Approval Page
Abstract
Acknowledgement
Dedications
Table of content
CHAPTER ONE
Introduction
CHAPTER TWO
Literature Review
CHAPTER THREE
Tools Used
CHAPTER FOUR
Final Test and Sequence of Opera.
CHAPTER FIVE
Conclusion
Reference
Appendix Two
Disclaimer: Note this academic material is intended as a guide for your academic research work. Do not copy word for word. Note: For Computer or Programming related works, some works might not contain source codes
CITE THIS WORK
(2013, 02). Repair And Rehabilitation Of A Faculty Refrigerator.. ProjectStoc.com. Retrieved 02, 2013, from https://projectstoc.com/read/923/repair-and-rehabilitation-of-a-faculty-refrigerator
"Repair And Rehabilitation Of A Faculty Refrigerator." ProjectStoc.com. 02 2013. 2013. 02 2013 <https://projectstoc.com/read/923/repair-and-rehabilitation-of-a-faculty-refrigerator>.
"Repair And Rehabilitation Of A Faculty Refrigerator.." ProjectStoc.com. ProjectStoc.com, 02 2013. Web. 02 2013. <https://projectstoc.com/read/923/repair-and-rehabilitation-of-a-faculty-refrigerator>.
"Repair And Rehabilitation Of A Faculty Refrigerator.." ProjectStoc.com. 02, 2013. Accessed 02, 2013. https://projectstoc.com/read/923/repair-and-rehabilitation-of-a-faculty-refrigerator.
- Related Works
- Design And Fabrication Of Mini Copula Furnace And An Atomizer For The Production Of Powdered Metal From Waste Aluminium Cans
- Construction Of A Potable Electric Operated With Radio Control (wireless Remote) Motor Vehicle For Long Valve Bus
- M Design And Fabrication Of Mobile Deep Freezer
- Design And Construction Of Slab For Water Reservoir
- Design And Construction Of Motorised Wheel Barrow
- The Design Of A Modern Railway Station
- Design And Construction Of A 2000w Inverter
- Design And Fabrication Of A Mechanism For Opening And Closing Of High Window Of A Church
- Design And Construction Of A Metallic Book Shelf
- The Construction And Fabrication Of Bench Shearing Machine