ABSTRACT
The project is about fabrication of wheel-barrow, which is fabricated in Mechanical Engineering workshop in Institute of Management and Technology, Enugu.
The report comprises seven chapters. Chapter one is about the introduction of the wheel. Chapter two is about the literature review, chapter three is about the material selection and analysis/ manufacturing processes.
Chapter four is about construction of the prototype and optimization /maintenance. Chapter five is about testing one evaluation. Chapter six is about costing analysis conclusion and recommendation while chapter seven talks about references.
TABLE OF CONTENT
Title page
Letter of transmittal
Release page
Approval page
Dedication
Acknowledgment
Abstract
Table of content
CHAPTER ONE
Introduction
CHAPTER TWO
Literature Review
CHAPTER THREE
Material selection and analysis
Manufacturing processes
CHAPTER FOUR
Construction of the prototype
Optimization/ maintenance
CHAPTER FIVE
Testing and evaluation
Costing analysis
CHAPTER SIX
Conclusion and recommendation
Reference
Disclaimer: Note this academic material is intended as a guide for your academic research work. Do not copy word for word. Note: For Computer or Programming related works, some works might not contain source codes
CITE THIS WORK
(2013, 02). Fabrication Of A Standard Wheelbarrow.. ProjectStoc.com. Retrieved 02, 2013, from https://projectstoc.com/read/922/fabrication-of-a-standard-wheelbarrow
"Fabrication Of A Standard Wheelbarrow." ProjectStoc.com. 02 2013. 2013. 02 2013 <https://projectstoc.com/read/922/fabrication-of-a-standard-wheelbarrow>.
"Fabrication Of A Standard Wheelbarrow.." ProjectStoc.com. ProjectStoc.com, 02 2013. Web. 02 2013. <https://projectstoc.com/read/922/fabrication-of-a-standard-wheelbarrow>.
"Fabrication Of A Standard Wheelbarrow.." ProjectStoc.com. 02, 2013. Accessed 02, 2013. https://projectstoc.com/read/922/fabrication-of-a-standard-wheelbarrow.
- Related Works
- A Termpaper On Stress Concentration
- M Design And Fabrication Of Mobile Deep Freezer
- The Design And Cosntruction Of 1000kwa Stabilizer A Project Presented To The Department Of Electrical/electronics Engineering
- Design And Fabrication Of Mini Copula Furnace And An Atomizer For The Production Of Powdered Metal From Waste Aluminium Cans
- Design And Construction Of A Single Phase Auto-transformer Of Rating Ikva, 240v/110, 80 12v, 6v
- The Fabrication Of A Single Face Pressurized Kerosene Cooker
- Design And Implementation Of Computerized Budget Analysis System (case Study Of Enugu State Ministry Of Finance)
- Design And Implementation Of Computerized Stock Stock Marketing Report Report (a Case Study Of Nigeria Stock Exchanhe Commission)
- The Construction And Fabrication Of A Candle Moulding Machine
- Design And Construction Of Slab For Water Reservoir