ABSTRACT
Knowledge could only be obtained successively by the use of books for research. This can be achieved only by preserving books already purchased. As a result we fabricate a metallic shelf made up of metallic sheet; precisely mild steel sheets. The mild steel used for the fabrication of the shelf is 1.5mm (16gauge) mild steel.
The shelf is made up of 3 partitions. In fabricating the metallic shelf several process where involved. We plundered on the material to be used that can hold the number of the books i.e. the strength of the material.
Thereafter accurate measurements of the mild sheets were made we also considered the rigidity of the metallic shelf. This led us to using square pipes for the support of the shelf. The square pipes were also measured to give the dimensions use.
The already cut square pipes were used form the frame by welding it together. Then the already measured and cut mild sheets were also welded to the frame. The doors are made up of the square pipes and wire gauze welded together. The shelf was also painted to give good outlook after smoothening and filling. Rollers were also fixed beneath to enhance good and easy movement of the shelf due to its weight.
TABLE OF CONTENT
Title Page
Letter of Transmittal
Release Page
Signature Page
Approval Page
Dedication
Acknowledgement
Abstract
CHAPTER ONE
1.1 Introduction
1.2 Description of the bookshelf
CHAPTER TWO
2.1 Mode of Operation
2.2 Material selection
CHAPTER THREE
3.1 Fabrication
3.2 Fabrication Analysis
3.3 Capacity of The Bookshelf
3.4 Fabrication Experiment
3.5 Construction
3.6 Sequence of Operation
CHAPTER FOUR
4.1 Cost of Analysis
CHAPTER FIVE
5.1 Conclusion
5.2 Recommendation
Reference
Disclaimer: Note this academic material is intended as a guide for your academic research work. Do not copy word for word. Note: For Computer or Programming related works, some works might not contain source codes
CITE THIS WORK
(2014, 11). Fabrication Of A Metallic Bookshelf.. ProjectStoc.com. Retrieved 11, 2014, from https://projectstoc.com/read/5184/fabrication-of-a-metallic-bookshelf-5024
"Fabrication Of A Metallic Bookshelf." ProjectStoc.com. 11 2014. 2014. 11 2014 <https://projectstoc.com/read/5184/fabrication-of-a-metallic-bookshelf-5024>.
"Fabrication Of A Metallic Bookshelf.." ProjectStoc.com. ProjectStoc.com, 11 2014. Web. 11 2014. <https://projectstoc.com/read/5184/fabrication-of-a-metallic-bookshelf-5024>.
"Fabrication Of A Metallic Bookshelf.." ProjectStoc.com. 11, 2014. Accessed 11, 2014. https://projectstoc.com/read/5184/fabrication-of-a-metallic-bookshelf-5024.
- Related Works
- Parametric Performance Evaluation Of A Window Unit Air-conditioner And Its Maintenance
- Design And Construction Of A Mobile Refrigerator
- The Design And Fabrication Of A Corn Selling Machine
- Fabrication Of A Polythiene Bag Sealing And Cutting Machine
- Design And Fabrication Of A Mechanism For Opening And Closing Of High Window Of A Church
- Construction Of A Model Shell And Tube Heat Exchanger
- Design And Fabrication Of A Dust Extractor
- Repair Of Stop Clocks
- Design And Fabrication Of An Electric Stove / Oven
- Design And Fabrication Of A Printing I Block Machine