ABSTRACT
Engineering being the mother every technology cannot be neglected. Without practical application in the field of engineering. The student and their tutors are impotent. The lucrative nature of engineering depends on the technical know-how of the engineer.
The purpose of practical project to students is to help them acquire practical knowledge in their choosing area of specification. It helps them to have a foretaste of the real world.
This report is a comprehensive report on the practices project I did. Precisely, with adequate knowledge and preparation, the student will celebrate victory from time to time.
TABLE OF CONTENT
Title Page
Dedication
Acknowledgement
Preface
Table of Content
Abstract
CHAPTER ONE
1.0INTRODUCTION
CHAPTER TWO
2.0Literature Review
2.1Component Description
2.2Capacitor
2.2.1Characteristic of Capacitors
2.3Resistor
2.4Transformer
2.5Transistor
2.6Diode
CHAPTER THREE
3.0Principle of Operation
3.1Block Diagram
3.2 Circuit Diagram
3.3Wiring Diagram
CHAPTER FOUR
4.0CONSTRUCTION
4.1How the Construction was Made
4.2Construction of the Chassis (Casing)
4.3Flat Pattern Drawing of the Chassis
4.4Tools used During Construction
CHAPTER FIVE
5.0TESTING & RESULT
CHAPTER SIX
6.0RECOMMENDATION AND CONCLUSION
6.1Recommendation
6.2Conclusion
6.3Reference
Disclaimer: Note this academic material is intended as a guide for your academic research work. Do not copy word for word. Note: For Computer or Programming related works, some works might not contain source codes
CITE THIS WORK
(2013, 03). The Construction Of Two Feet Electronics Fluorescent Lamp.. ProjectStoc.com. Retrieved 03, 2013, from https://projectstoc.com/read/1237/the-construction-of-two-feet-electronics-fluorescent-lamp
"The Construction Of Two Feet Electronics Fluorescent Lamp." ProjectStoc.com. 03 2013. 2013. 03 2013 <https://projectstoc.com/read/1237/the-construction-of-two-feet-electronics-fluorescent-lamp>.
"The Construction Of Two Feet Electronics Fluorescent Lamp.." ProjectStoc.com. ProjectStoc.com, 03 2013. Web. 03 2013. <https://projectstoc.com/read/1237/the-construction-of-two-feet-electronics-fluorescent-lamp>.
"The Construction Of Two Feet Electronics Fluorescent Lamp.." ProjectStoc.com. 03, 2013. Accessed 03, 2013. https://projectstoc.com/read/1237/the-construction-of-two-feet-electronics-fluorescent-lamp.
- Related Works
- Construction Of A Microcontroller Based T-junction Traffic Light Controller
- Design And Construction A Simple Light Sensitive Circuit
- Automatic Door Opening Systems Using Ir Sensors
- Design And Implementation Of A Solar Power System
- Construction Of A 12v Battery Charger
- Design And Construction Of A Single Phase Microcontroller Based Automatic Changeover With Generator Starter
- Design And Construction Of An Electronic Attendance Staff Register (ear).
- Construction Of A 12 Volt Battery Charger
- The Dependence Of Water Level On Electrical Power Generation Using Jebba Hydropower Station As Case Study
- Construction Of A Microcontroller Based Security Door Using Smart Card