ABSTRACT
This project is concerned with the fabrication of as a single face pressurized kerosene cooker. The report shows the possible way in which the above mentioned can be designed, fabricated and maintained.
Its also shows the strength and properties of the materials it is made of.
Defects of the equipment can come through inability to maintain and inability to use well.
It can be due to irregular cleaning of pressurized parts, exposure to rain, moisture and sunlight as well as insufficient kerosene and air pressure in the tank before usage. Before fabricating, the properties of materials and kind of material involved are put into consideration.
The parts and its functions are described.
TABLE OF CONTENT
Title Page
Letter of Transmittal
Signature Page
Release Page
Approval Page
Dedication
Acknowledgement
Table of Content
Abstract
CHAPTER ONE
Introduction
CHAPTER TWO
Literature Review
2.1 How the stove work
CHAPTER THREE
Design Analysis
CHAPTER FOUR
4.1 Material Selection
4.2 Component Parts
4.3 Description of the component part
4.3 Constructional features of the stove
CHAPTER FIVE
5.1 Method of Operation
5.2 Maintenance
5.3 Capacity
5.4 Detection of kerosene shortage
CHAPTER SIX
Cost Estimates
6.1 Material cost Analysis
6.2 Machine cost Analysis
6.3 Labour cost Analysis
CHAPTER SEVEN
7.1 Conclusion
7.2 recommendation
references
Disclaimer: Note this academic material is intended as a guide for your academic research work. Do not copy word for word. Note: For Computer or Programming related works, some works might not contain source codes
CITE THIS WORK
(2013, 03). The Fabrication Of A Single Face Pressurized Kerosene Cooker.. ProjectStoc.com. Retrieved 03, 2013, from https://projectstoc.com/read/1151/the-fabrication-of-a-single-face-pressurized-kerosene-cooker
"The Fabrication Of A Single Face Pressurized Kerosene Cooker." ProjectStoc.com. 03 2013. 2013. 03 2013 <https://projectstoc.com/read/1151/the-fabrication-of-a-single-face-pressurized-kerosene-cooker>.
"The Fabrication Of A Single Face Pressurized Kerosene Cooker.." ProjectStoc.com. ProjectStoc.com, 03 2013. Web. 03 2013. <https://projectstoc.com/read/1151/the-fabrication-of-a-single-face-pressurized-kerosene-cooker>.
"The Fabrication Of A Single Face Pressurized Kerosene Cooker.." ProjectStoc.com. 03, 2013. Accessed 03, 2013. https://projectstoc.com/read/1151/the-fabrication-of-a-single-face-pressurized-kerosene-cooker.
- Related Works
- The Design And Fabrication Of A Pressurized Kerosene Oven (60 X 90)
- The Design And Cosntruction Of 1000kwa Stabilizer A Project Presented To The Department Of Electrical/electronics Engineering
- Construction Of A Screw Conveyor With A Single Phase Electric Motor
- Repair And Fabrication Of A Refrigerator System
- Construction Of Industrial Barrow
- Repair And Rehabilitation Of A Faulty Deep Freezer
- Design And Fabrication Of An Air Driven Engine
- Design And Construction Of Electric Blower For Forge Or Furnace
- A Termpaper On Types, Selection And Design Of Bearing
- Design And Construction Of Slab For Water Reservoir