ABSTRACT
The constructional project involved the construction of an industrial barrow of standard size was constructed.
The process used went across various Engineering practice. These involved the procurement of galvanized steel of 0.00mm to 300mm thickness. Some galvanized steel rods and pipes were also used for the construction.
The Engineering drawing was done followed by the following operation: Marking out, cutting, bending and folding.
Finally, the construction of an industrial barrow was done successfully and clean, portable and standard industrial barrow was obtained. These industrial barrows can be used in material handling activities.
TABLE OF CONTENTS
Title page
Dedication
Acknowledgement
Letter of posterity / Transmittal
Abstract
Content
CHAPTER ONE
1.0Introduction
1.1Origin and History
1.2Aim
CHAPTER TWO
Literature review
CHAPTER THREE
3.0Sequence of operation
3.1Prototype construction
3.2Operation description
3.3Material analysis
3.4Testing of construction and analysis
3.5Testing and results.
CHAPTER FOUR
4.0Cost evaluation
4.1Cost of standard wheel
CHAPTER FIVE
Discussion
CHAPTER SIX
Recommendation
Conclusion
CHAPTER SEVEN
Bibliography
Disclaimer: Note this academic material is intended as a guide for your academic research work. Do not copy word for word. Note: For Computer or Programming related works, some works might not contain source codes
CITE THIS WORK
(2012, 12). Construction Of Industrial Barrow.. ProjectStoc.com. Retrieved 12, 2012, from https://projectstoc.com/read/480/construction-of-industrial-barrow
"Construction Of Industrial Barrow." ProjectStoc.com. 12 2012. 2012. 12 2012 <https://projectstoc.com/read/480/construction-of-industrial-barrow>.
"Construction Of Industrial Barrow.." ProjectStoc.com. ProjectStoc.com, 12 2012. Web. 12 2012. <https://projectstoc.com/read/480/construction-of-industrial-barrow>.
"Construction Of Industrial Barrow.." ProjectStoc.com. 12, 2012. Accessed 12, 2012. https://projectstoc.com/read/480/construction-of-industrial-barrow.
- Related Works
- Project Repair And Fabrication Of A Refrigerator System
- A Termpaper On Types, And Design Of Brakes
- Design And Construction Of A Single Phase Auto-transformer Of Rating Ikva, 240v/110, 80 12v, 6v
- Construction Of A Model Shell And Tube Heat Exchanger
- The Design Of A Modern Railway Station
- Construction Of A Potable Electric Operated With Radio Control (wireless Remote) Motor Vehicle For Long Valve Bus
- Technical Report On The Fabrication Of A Fan Blade
- Design And Construction Of Slab For Water Reservoir
- Design And Fabrication Of An Air Driven Engine
- Design And Fabrication Of 80cm X 70cm X 50cm Mobile Deep Freezer