ABSTRACT
Knowledge could only be obtained successively by the use of books for research. This can be achieved only by preserving books already purchased. As a result we fabricate a metallic shelf made up of metallic sheet. Precisely mild steel sheets. The mild steel used for the fabrication of the shelf is 1.5mm (16gauge) mild steel.
The shelf is made up of 3 partition. In fabricating the metallic shelf several process where involved. We plundered on the material to be used that can hold the number of the books i.e. the strength of the material.
Thereafter accurate measurements of the mild sheets were made we also considered the rigidity of the metallic shelf. This led us to using square pipes for the support of the shelf. The square pipes were also measured to give the dimensions use.
The already cut square pipes were used form the frame by welding it together. Then the already measured and cut mild sheets were also welded to the frame. The doors are made up of the square pipes and wire gauze welded together. The shelf was also painted to give good outlook after smoothening and filling. Rollers were also fixed beneath to enhance good and easy movement of the shelf due to its weight.
TABLE OF CONTENT
Title Page ii
Letter of Transmittal iii
Release Page iv
Signature Page v
Approval Page vi
Dedication vii
Acknowledgement viii
Table of content ix
Abstract xi
CHAPTER ONE
1.1 Introduction 1
1.2 Description of the bookshelf 2
CHAPTER TWO
2.1 Mode of Operation 6
2.2 Material selection 8
CHAPTER THREE
3.1 Fabrication 10
3.2 Fabrication Analysis 10
3.3 Capacity of The Bookshelf 12
3.4 Fabrication Experiment 12
3.5 Construction 14
CHAPTER FOUR
4.1 Cost of Analysis 17
CHAPTER FIVE
5.1 Conclusion 20
5.2 Recommendation 21
Reference 22
Disclaimer: Note this academic material is intended as a guide for your academic research work. Do not copy word for word. Note: For Computer or Programming related works, some works might not contain source codes
CITE THIS WORK
(2014, 10). Fabrication Of The A Metallic Bookshelf.. ProjectStoc.com. Retrieved 10, 2014, from https://projectstoc.com/read/3807/fabrication-of-the-a-metallic-bookshelf-2594
"Fabrication Of The A Metallic Bookshelf." ProjectStoc.com. 10 2014. 2014. 10 2014 <https://projectstoc.com/read/3807/fabrication-of-the-a-metallic-bookshelf-2594>.
"Fabrication Of The A Metallic Bookshelf.." ProjectStoc.com. ProjectStoc.com, 10 2014. Web. 10 2014. <https://projectstoc.com/read/3807/fabrication-of-the-a-metallic-bookshelf-2594>.
"Fabrication Of The A Metallic Bookshelf.." ProjectStoc.com. 10, 2014. Accessed 10, 2014. https://projectstoc.com/read/3807/fabrication-of-the-a-metallic-bookshelf-2594.
- Related Works
- Design And Construction Of A Manual Chips Packaging Machine
- Construction Of An Electrical Stove With Three-oven Apartment
- Construction Of A Standard Drawing Desk
- Construction Of Packed Distillation Column
- Selection Of Water Pumps
- Repair Of A Faulty Refrigerator In The Mechanical Engineering Department Of The Institute Of Management And Technology, Enugu
- Design And Construction Of A Spin Dryer
- Design And Fabrication Of Creep Material Testing Equipment
- The Construction Of Industrial Fan For Workshop Use
- Design And Performance Evaluation Of An Ice Block Making Machine