ABSTRACT
The aim of this design work is to allow traffic light to rotate over a designated time interval between the two roads concerned i.e IMT and ESUT Junction. This design will control and monitor devices and cars within its environment i.e the junction.
It will as well steer small vehicles showing them how to obey the traffic instructions coming from the traffic signals. The system is designed to operate in a red time mode to monitor the volume of traffic light.
The project will determine whether any of the devices is defective and of the same time, send signals to indicate faulty devices. The software also includes the maintenance of these devices giving warning signs wherever a fault is detected.
The software is designed to detect the flow of traffic showing how and when vehicles will be passed or in order words, it is the aim of the project to solve problems as a result of manual and simulate the existing system into a new system.
TABLE OF CONTENTS
Title Page
Certification
Dedication
Acknowledgement
Abstract
Organization of the work
CHAPTER ONE
1.0 Introduction
1.1 Statement of problem
1.2 Purpose of the study
1.3 Aims and objectives
1.4 Scope or Delimitations
1.5 Limitations and constraints
1.6 Assumptions
1.7 Definition of terms
CHAPTER TWO
2.0 Review of related literature
CHAPTER THREE
Description and analysis of the existing system
3.1 Fact finding methods
3.2 Organizational structure
3.3 Objectives of the existing system
3.3 Input, process, output analysis
3.4 Input, process, output analysis
3.5 Information flow diagram
3.6 Problems of the existing system
3.6 Justification of the new system
CHAPTER FOUR
Design of the new system
4.1 Output specification and design
4.2 Input specification and design
4.3 File design
4.4 Procedure chart
4.5 System flowchart
4.6 System requirement
CHAPTER FIVE
Implementation
5.1 Program design
5.2 Source program
5.3 Program flowchart
5.4 Pseudocades
5.5 Test run
CHAPTER SIX
Documentation
6.1 System documentation
6.2 Program documentation
6.3 User documentation
CHAPTER SEVEN
Conclusion and Recommendation
7.1 Conclusion
7.2 Recommendation
Bibliography
Disclaimer: Note this academic material is intended as a guide for your academic research work. Do not copy word for word. Note: For Computer or Programming related works, some works might not contain source codes
CITE THIS WORK
(2014, 12). Design And Simulation Of Traffic Control System For A T-junction A Case Study Of Esut-imt Road Junction.. ProjectStoc.com. Retrieved 12, 2014, from https://projectstoc.com/read/5547/design-and-simulation-of-traffic-control-system-for-a-t-junction-a-case-study-of-esut-imt-road-junction-5465
"Design And Simulation Of Traffic Control System For A T-junction A Case Study Of Esut-imt Road Junction." ProjectStoc.com. 12 2014. 2014. 12 2014 <https://projectstoc.com/read/5547/design-and-simulation-of-traffic-control-system-for-a-t-junction-a-case-study-of-esut-imt-road-junction-5465>.
"Design And Simulation Of Traffic Control System For A T-junction A Case Study Of Esut-imt Road Junction.." ProjectStoc.com. ProjectStoc.com, 12 2014. Web. 12 2014. <https://projectstoc.com/read/5547/design-and-simulation-of-traffic-control-system-for-a-t-junction-a-case-study-of-esut-imt-road-junction-5465>.
"Design And Simulation Of Traffic Control System For A T-junction A Case Study Of Esut-imt Road Junction.." ProjectStoc.com. 12, 2014. Accessed 12, 2014. https://projectstoc.com/read/5547/design-and-simulation-of-traffic-control-system-for-a-t-junction-a-case-study-of-esut-imt-road-junction-5465.
- Related Works
- Application Of Information And Communication Technology (ict) In Sustaining Cooperative Development In Nigeria
- Design And Implementation Of A Computerized Invoicing System (a Case Study Of Bubbles Plaza Enugu)
- Error Detection And Correction In Data Communications Using Parity Bit And Cyclic Redundancy Check
- New Scheduling Algorithms For Differentiated Services Network
- Using Trigonometry And Pythagoras To Watermark An Image
- Design And Implementation Of Html Editor (case Study Of Microsoft Corporation)
- Distributed Channel Management System
- Design And Implementation Of A Computerized Transaction Receipt Generating System For An Atm Machine (a Case Study A Union Bank Of Nigeria)
- Design And Implementation Of A Computerized Loan Disbursement Control System (a Case Study Of Union Bank Of Nigeria Plc Enugu)
- Design And Implementation Of An Online Student Record System. (a Case Study Of Imt Enugu, Enugu State)