ABSTRACT
This research was carried out with the sole aim of monitoring interface in the transportation of petroleum pipeline products and the analysis of this product from Enugu depot. In the research it was observed that product contaminates each other if interface was not properly monitored and cut at the appropriate time.
The three major products that were considered in this research were premium motor spirit (PMS) automotive gas premium (AGO0 and dual purpose kerosene (DPK).
The tests carried out point test smoke point test, initial and final boiling point test (Distillation), temperature and density test, to ascertain the standard quality specification and the extent of their purity.
It was observed from the result that the flash point value for DPK and AGO were 430c and 820c respectively. The average smoke point test values for DPK product was 21.92mm. the initial and final boiling point of PMS were350c and 1750c, respectively. The observed density at the DPK/AGO interface monitoring test were 819 kg/m3 and 850 kg/m3 and corrected densities for DPK and AGO were 830.2kg/m3 and 859.9kg/m3 respectively. The interface reception cut point for DPK/AGO interface monitoring was made at the corrected density of 849.0 kg/m3. And the temperature of DPK and AGO were 310c respectively.
The result from the analysis revealed that the boiling point of PMS was far more lower than that of AGI and DPK, which implies that PMS has a higher volatility than the two other products the flash point test revealed that the minimum temperature at which AGO and DPK ignites was 66.50c and 430c PMS was not determined because of its high volatility. Also, the standard minimum smoke point of DPK was determined to be 22mm. The smoke point test for AGO and PMS were not carried out because, they were not domestically used and their combustion normally takes value in an engine.
This research has become very necessary because it reveals the proper way pf handling petroleum pipeline product to meet standard specification for domestic and industrial use.
TABLE OF CONTENTS
Title page
Approval page
Letter of transmittal
Dedication
Acknowledgement
Abstract
Table of contents
CHAPTER ONE
1.0 Introduction
1.1 Historical perspective
1.2 Introduction to petroleum transportation by pipeline
1.3 Product movements and handling
1.4 Batching procedure
1.5 Interface detection and control
1.6 Interface growth
1.7 Product quality control
1.8 Sample
1.9 Product contamination
CHAPTER TWO
2.0 Literature review
2.1 Historical review of interface
2.2 Pipeline hydraulics
2.3 Laminal and turbulent flow
2.4 The Reynolds number
2.5 Operating philosophy
CHAPTER THREE
3.0 Experimental method/ procedure
3.1 List of laboratory equipment
3.2 Experiment method
3.3 Interface monitoring test (first step)
3.4 Experimental test on the various pipeline product (second step)
3.4.1 Flash point test
3.4.2 Smoke point test
3.4.3 Distillation test
3.4.4 Temperature and relative density test
CHAPTER FOUR
4.0 Experimental results
CHAPTER FIVE
5.0 Discussion
CHAPTER SIX
6.0 Conclusion
CHAPTER SEVEN
7.0 Recommendation
References
Appendices
Disclaimer: Note this academic material is intended as a guide for your academic research work. Do not copy word for word. Note: For Computer or Programming related works, some works might not contain source codes
CITE THIS WORK
(2014, 10). Interface Monitoring And Analysis Of Pipeline And Products Marketing Company Limited Enugu Depot.. ProjectStoc.com. Retrieved 10, 2014, from https://projectstoc.com/read/3817/interface-monitoring-and-analysis-of-pipeline-and-products-marketing-company-limited-enugu-depot-7895
"Interface Monitoring And Analysis Of Pipeline And Products Marketing Company Limited Enugu Depot." ProjectStoc.com. 10 2014. 2014. 10 2014 <https://projectstoc.com/read/3817/interface-monitoring-and-analysis-of-pipeline-and-products-marketing-company-limited-enugu-depot-7895>.
"Interface Monitoring And Analysis Of Pipeline And Products Marketing Company Limited Enugu Depot.." ProjectStoc.com. ProjectStoc.com, 10 2014. Web. 10 2014. <https://projectstoc.com/read/3817/interface-monitoring-and-analysis-of-pipeline-and-products-marketing-company-limited-enugu-depot-7895>.
"Interface Monitoring And Analysis Of Pipeline And Products Marketing Company Limited Enugu Depot.." ProjectStoc.com. 10, 2014. Accessed 10, 2014. https://projectstoc.com/read/3817/interface-monitoring-and-analysis-of-pipeline-and-products-marketing-company-limited-enugu-depot-7895.
- Related Works
- Characteristics Of Local Produced Oil From Groundnut Oil
- Assessment Of Carbon Monoxide (co) Level In Enugu Metropolis Monitoring Industrial And Residential Area
- Absorption Of Palm Oil With Synthetic Adsorbent (coal)
- Design And Implementation Of A Window Based Front-desk Information System (a Case Study Of May Fresh Savings And Loan Limited Onitsha
- Construction Of Table Top Liquidliquid Extraction Unit
- Design And Implementation Of A Computerized Out-patient Information System For A Clinic (a Case Study Of Hansa Clinic Enugu)
- Formulation And Production Of Alcohol From Palm Wine.
- Construction Of 2,000 Litres Capacity Water Re-servoir
- Effect Of Interface On The Quality Of Petroleum Product In Multi Purpose Pipeline System
- Construction Of A Pilot Motorized Mixer